Heat & Glo LifeStyle 6000TRS-CE Manual Do Utilizador
Heat & Glo • 6000TRS-CE • 2049-900 Rev. Q • 2/11
37
Before lighting the fireplace, be sure to do the
following:
following:
Review safety warnings and cautions
• Read the Safety and Warning Information section at
the beginning of this Installers Guide.
Double-check for gas leaks
• Before lighting the fi replace, double-check the unit for
possible gas leaks.
Double-check fl ue terminations and front grilles for
obstructions.
obstructions.
• Before lighting the fi replace, double-check the unit for
possible obstructions that could be blocking the fl ue
terminations or the front grilles.
terminations or the front grilles.
Double-check for faulty components
• Any component that is found to be faulty MUST BE
replaced with an approved component. Tampering with
the fi replace components is DANGEROUS and voids
all warranties.
the fi replace components is DANGEROUS and voids
all warranties.
A small amount of air will be in the gas supply lines.
When fi rst lighting the fi replace, it will take a few minutes
for the lines to purge themselves of this air. Once the
purging is complete, the fi replace will light and will operate
normally.
When fi rst lighting the fi replace, it will take a few minutes
for the lines to purge themselves of this air. Once the
purging is complete, the fi replace will light and will operate
normally.
Subsequent lightings of the fi replace will not require this
purging of air from the gas supply lines, unless the gas
valve has been turned to the OFF position, in which
case the air would have to be purged.
purging of air from the gas supply lines, unless the gas
valve has been turned to the OFF position, in which
case the air would have to be purged.
NOTE: The fi replace should be run for 3 to 4 hours on
the initial start-up. Turn it off and let it cool completely.
Remove and clean the glass. Replace the glass and run
the fi replace for an additional 8 hours. This will help to
cure the products used in the paint and logs.
the initial start-up. Turn it off and let it cool completely.
Remove and clean the glass. Replace the glass and run
the fi replace for an additional 8 hours. This will help to
cure the products used in the paint and logs.
Step 11
Before Lighting
the Fireplace
Before Lighting
the Fireplace
WARNING
This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• DO NOT touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• DO NOT touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other fl ammable
materials.
• Keep clothing, furniture, draperies and other fl ammable
materials.
• Keep clothing, furniture, draperies and other fl ammable
materials away.