Vanguard Managed Solutions FLAME-MAX Manual Do Utilizador

3

105187

Control Knob

Base Assembly

Piezo Ignitor

Burner

One Piece Log Set

Control Knob

Piezo Ignitor

One Piece
Log Set

One Piece
Log Set

Control Knob

Piezo Ignitor

Base Assembly

Base Assembly

This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and ap-
proved to ANS Z21.11.2 standard for
unvented heaters. State and local codes in
some areas prohibit the use of vent-free
heaters. Non-thermostat models may also
be operated as a vented decorative  (ANS
Z21.60) product by opening flue damper.

This heater has a pilot with an Oxygen
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.

This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.

1.

Remove logs and heater base assem-
bly from carton. 

Note:

 Do not pick up

heater base assembly by the burner.
This could damage heater. Always
handle base assembly by grate.

2.

Remove all protective packaging ap-
plied to logs and heater for shipment.

3.

Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.

Install and use heater with care. Follow all local
codes. In the absence of local codes, use the
latest edition of The National Fuel Gas Code
ANS Z223.1, also known as NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY  10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA  02269

Note: 

Where listed vented decorative logs

are required, thermostat models are not per-
mitted.

Control Knob

Piezo Ignitor

One Piece
Log Set

Base Assembly