Majestic Appliances 3374 Manual Do Utilizador

13

Vermont Castings Radiance Vent-Free Gas Heater

20004555

1. Remove left and right log bracket assembly by
unfastening the two screws which hold the burner in
place. Loosen the screw on the rear log bracket and
remove the bracket.

2. Hold the burner at the right hand side and lift to clear
the right burner leg. Then pull to the right to clear the
injectors on the left hand side.

3. Turn burner upside down and remove air shutter.
Discard air shutter. (Fig. 18)

Black

Black

TP/TH

TP

TH

Black

Black

TP/TH

TP

TH

ST124b

ST124c

90¡

Left Burner Leg

Injector Orifices

ST353a

Fig. 19  Be sure injector orifices remain at 90

°

 to the base.

4. Replace burner. Slide the burner in at an angle with
left side lower than the right side. Slide the left side
onto the injectors, making sure the burner leg remains
at a 90

°

 angle to the base. (Fig. 19) Lower the right

hand side down in to place. Make sure the burner is as
far left as possible and the injector shoulders are inside
the burner.

5. Replace left and right log bracket assembly, tighten
rear log bracket, and replace logs.

6. Latches provided in catalyst kit must be installed on
top of firebox. Use two phillips screws to secure in
place. (Fig. 20)

7. Slide catalyst between top plate and firebox. Allow
catalyst to “fall” into hole on top of firebox. Secure with
two screws as shown in Figure 21.

Phillips
Screws

Phillips Screws

ST671

Fig. 20  Attach glass latches.

Catalyst Location

Air Shutter (Remove and Discard)

Bottom of Burner Pan

ST667

Fig. 18  Remove air shutter and discard.

ST201

Fig. 21  Install catalytic combustor.