Majestic Appliances 3374 Manual Do Utilizador
5
Vermont Castings Radiance Vent-Free Gas Heater
20004555
Clearance Requirements
Minimum Clearances to
Combustible Materials
Maintain clearance, (empty space), between combus-
tible materials and the heater as specified below.
tible materials and the heater as specified below.
Hearth Requirements
The Radiance Unvented heater must be installed on
rigid flooring. If the appliance is installed on any
combustible surface other than wood flooring, such as
carpet or tile, a metal or wood panel must be installed
to extend the full length and width of the unit. There
are no other hearth or floor protection requirements.
rigid flooring. If the appliance is installed on any
combustible surface other than wood flooring, such as
carpet or tile, a metal or wood panel must be installed
to extend the full length and width of the unit. There
are no other hearth or floor protection requirements.
Fig. 3 Minimum mantel clearance.
A
B
C
D
E
V
W
X
Y
Z
Mantel
Mantel from
Ref.
Shelf Depth
Ref.
Stove Top
A
7
¹⁄₂
” (190mm)
V
16” (406mm)
B
6” (152mm)
W
14
¹⁄₂
” (368mm)
C
4
¹⁄₂
” (114mm)
X
13” (330mm)
D
3” (75mm)
Y
11
¹⁄₂
” (292mm)
E
1
¹⁄₂
” (38mm)
Z
10” (254mm)
ST694
Wall
B
B
D
A
C
A: Maximum Alcove Depth .............. 24" (609mm)
B: To Side Wall ................................... 4" (101mm)
C: To Rear Wall ................................. 4" (101mm)
D: To Ceiling ................................... 60" (1524mm)
B: To Side Wall ................................... 4" (101mm)
C: To Rear Wall ................................. 4" (101mm)
D: To Ceiling ................................... 60" (1524mm)
Alcove Clearances
ST103a
B
A
A: To Side Wall / Trim* ........................ 4" (101.6mm)
B: To Rear Wall ................................... 4" (101.6mm)
B: To Rear Wall ................................... 4" (101.6mm)
ST101
Fig. 2 Minimum wall clearances.
• Do not install this heater in a bathroom or
bedroom.
bedroom.
• Installation of this heater must conform with
local codes or, in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1.
local codes or, in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1.
• This heater creates warm air currents. These
currents move heat to wall surfaces next to the
heater. Installing the heater next to vinyl or cloth
wall coverings or operating the heater where
impurities in the air such as tobacco smoke exist,
may discolor walls.
currents move heat to wall surfaces next to the
heater. Installing the heater next to vinyl or cloth
wall coverings or operating the heater where
impurities in the air such as tobacco smoke exist,
may discolor walls.
• Do not use a blower insert, heat exchanger
insert or other accessory not approved for use
with this heater.
insert or other accessory not approved for use
with this heater.
WARNING