Majestic Appliances 3374 Manual Do Utilizador
9
Vermont Castings Radiance Vent-Free Gas Heater
20004555
Read these instructions thoroughly before starting
the assembly. Follow procedures in the order
given. Inspect the stove for damage before starting
the assembly. Do not install this stove if any
damage is evident. Contact your dealer immedi-
ately.
the assembly. Follow procedures in the order
given. Inspect the stove for damage before starting
the assembly. Do not install this stove if any
damage is evident. Contact your dealer immedi-
ately.
The Radiance is shipped on its back, mounted to a
wooden pallet. It is fully assembled, although packing
materials must be removed from the firebox and the
Log Set installed. Connection to the gas supply must
be performed only by a qualified gas technician who
should also verify that adequate ventilation is available
to support proper burner function.
wooden pallet. It is fully assembled, although packing
materials must be removed from the firebox and the
Log Set installed. Connection to the gas supply must
be performed only by a qualified gas technician who
should also verify that adequate ventilation is available
to support proper burner function.
Installation of optional accessories, such as the Fan,
Glass/Catalyst, or thermostat, is most easily accom-
plished before the gas supply connection is made.
Glass/Catalyst, or thermostat, is most easily accom-
plished before the gas supply connection is made.
Tools Required
•
Stub-handled Phillips screwdriver
• work gloves
•
Standard Phillips screwdriver
• knife
•
Standard flat-blade screwdriver
•
Tape measure
• needlenose pliers
Hardware Bag Contents
•
Porcelain Handle (Front Door)
•
Control Door Handle & Screw
•
(2) Bags of Lava Rock
•
(6) 10 x 1/2” Screws
•
Bracket, Wire Switch
•
Registration Card & Manual
•
(4) CS, Hex Hd 3/8-16 x 1 Gr 2-Z
•
(4) Washer, Fl 3/8-Z
Unpacking the Radiance
Caution: Enamelled castings can chip easily!
Handle enamelled castings carefully to avoid
damage.
Handle enamelled castings carefully to avoid
damage.
1. Cut the shipping straps.
2. Unpack the top grate and screen from the carton,
2. Unpack the top grate and screen from the carton,
and set them aside.
Remove the Front, Screen and Logs
Remove the Front panel, the Screen panel, the Log
Set and hardware bag from the firebox before position-
ing the stove.
1. Remove the accessory package from the top of the
Set and hardware bag from the firebox before position-
ing the stove.
1. Remove the accessory package from the top of the
stove.
The manual, hardware package, and lava
rocks are packed on top of the firebox. Set these
aside.
aside.
2. Remove the Front Plate. Grasp one side and the
bottom, and lift the front plate as a unit (the control
door attaches to the stove front). Swing the bottom
edge out and away from the stove body, (Fig. 5)
door attaches to the stove front). Swing the bottom
edge out and away from the stove body, (Fig. 5)
3. Remove the screen frame. (Fig. 6)
4. Remove the Log Set.
4. Remove the Log Set.
Lift out the package and any
packing material from the burner tray and firebox.
Unpack the log set and inspect each piece for
damage. DO NOT INSTALL DAMAGED LOGS. Set
the logs aside out of the way.
Unpack the log set and inspect each piece for
damage. DO NOT INSTALL DAMAGED LOGS. Set
the logs aside out of the way.
Assembly Procedures
Fig. 5 Remove the front plate.
ST139
Fig. 6 Lift screen from firebox.
ST187a
Screen Hooks