Faber SP4 Manual Do Utilizador

Mark the bottom hole position (see Fig. 5), remove the heater
ensuring that the bottom fixing bracket is rotated up.

Drill and fit wall plug.

Refit the heater to the wall fixing bracket (i.e. follow steps as
in Fig. 4 a,b,c and d above) and rotate the bottom fixing
bracket down again and use the screw provided to
permanently fix the heater in place.

The heater should not be connected until the instruction leaflet
is read fully.

This model is designed to be permanently fixed to a wall at a
minimum height of 300mm.

The wall bracket must be fitted horizontally and the cable
routed to the bottom right of the heater as in Fig 1.

A height of 600mm from bottom of heater to floor is
recommended for optimum viewing of fuel bed (see Fig. 2
for recommended fixing dimensions).

For optimum viewing mark the top 

four

 screw fixing positions

on wall in accordance with the recommended fixing
dimensions - see  Fig. 2.

Drill holes with a 6mm drill bit.

  Fix the wall bracket using the

four

 plugs and screws provided  -  see Fig 3.

Carefully lift the heater up ensuring that the top rear ledge of
heater engages the wall bracket and is sitting centrally
positioned.  - see Fig 4 (b).

Rotate the bottom fixing bracket down. - see Fig 4 (c).

Gently bring the heater level with the wall. - see Fig 4 (d).

wall
plugs

screws

wall
fixing
bracket

8

566

240

600

1158

558

480

outline of
 wall fire

outline of wall
fixing bracket

mark hole
centre with
pencil

wall

bracket

ledge

ensure ledge
at back of 
fire engages
wall bracket

Detail ’1’

wall bracket

see 
detail ’1’

a

lift appliance
above wall
fixing bracket

rotate bottom

fixing bracket
down from its
transit position

c

d

bring level 

with wall

slide down over
bracket, ensure
that ledge of
appliance engages
behind wall
bracket and is
central 

b