Empire Comfort Systems BF-30-2 Manual Do Utilizador

Page 10

16943-5-0806

TO TURN OFF GAS TO APPLIANCE

1.   STOP!   Read the safety information above.
2.  Set thermostat (gas control knob) to lowest setting.
3.  Turn off all electric power to the appliance (if applicable).
4.   Push in gas control knob slightly and turn clockwise 

 

 to "OFF".  Do not force.

 
5.   Wait ten (10) minutes   to clear out any gas.  Then smell for 

gas, including near the floor.  If you smell gas, STOP! Follow 

"B" in the safety information above.  If you don't smell gas, 

go to the next step.

6.   Find pilot - the pilot is 

 

attached at the bottom of 

 

the burner assembly .

7.   Turn gas control knob
 

counterclockwise 

  to "PILOT."

8.   Push in gas control knob all the way and hold in.  Repeatedly 

push the piezo ignitor button until pilot is lit (or use a match 

to light pilot).  Continue to hold the control knob in for about 

one (1) minute after the pilot is lit.  Release knob and it will 

pop back up.  Pilot should remain lit.  If it goes out, repeat 

steps 4 through 8.
•  If knob does not pop up when released, stop and im-

mediately call your service technician or gas supplier.  

•  If the pilot will not stay lit after several tries, turn the gas 

control knob to "OFF" and call your service technician 

or gas supplier.  

 9.  Attention!  Gas control has an INTERLOCK latching device.  

When the pilot is initially lit and the safety magnet is ener-

gized (pilot stays "ON") the INTERLOCK latching device 

becomes operative.  If the gas control is turned to the "OFF" 

position or gas flow to the appliance is shut off, the pilot 

cannot be relighted until the safety magnet is de-energized 

(approximately 60 seconds).  There will be an audible "click" 

when the safety magnet in the gas control is de-energized.  

Pilot can now be relighted.  Repeat steps 4 through 8.

10.  Turn gas control knob counterclockwise   

 

 

to "HI". 

11.  Turn on all electric power to appliance (if applicable).
12.  Set thermostat (gas control knob) to desired setting from "HI" 

to "LO".

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING:  If you do not follow these instructions exactly, a fire or explosion may result caus-

ing property damage, personal injury or loss of life.

A.   This appliance has a pilot which must be lighted by hand.  

When lighting the pilot, follow these instructions exactly.

B.   BEFORE LIGHTING  smell all around the appliance area 

for gas.  Be sure to smell next to the floor because some gas 

is heavier than air and will settle on the floor.

 

WHAT TO DO IF YOU SMELL GAS

•  Do not try to light any appliance.

•  Do not touch any electrical switch; 

 

do not use any phone in your building.

•  Immediately call your gas supplier from a neighbor's 

phone.  Follow the gas supplier's instructions.

•  If you cannot reach your gas supplier, call the fire depart-

ment.

C.   Use only your hand to push in or turn the gas control knob.  

Never use tools.  If the knob will not push in or turn by hand, 

don't try to repair it; call  a  qualified service technician.  Force 

or attempted repair may result in a fire or explosion.

D.   Do not use this appliance if any part has been under water.  

Immediately call a qualified service technician to inspect the 

appliance and to replace any part of the control system and 

any gas control which has been under water.

1.   Set thermostat (gas control knob) to lowest setting.
2.   Turn off all electric power to appliance if service is to be 

performed (if applicable).

3.   Push in gas control knob slightly and turn clockwise  

 to "OFF".  Do not force.

LIGHTING INSTRUCTIONS