Enerco MH12C Manual Do Utilizador

Operating Instructions and Owner’s Manual

Mr. Heater | Gas-Fired Infra-Red Portable Heater

HOOK-UP INFORMATION

1.1 Heater models MH12C and MH12CS are packaged completely

assembled except for metal stand. Propane cylinders are not
included with models MH12C and MH12CS.

1.2 Remove heater from carton.

1.3 Hold heater in one hand and with the other hand hold

propane cylinder vertically and carefully turn clockwise into
heater valve-regulator until snug. (Careful not to cross-thread)
– Fig. 1 and Fig. 2.

1.4 Use only LP-gas cylinders constructed for use with propane

only (HD-5) and marked in accordance with the specifications
for LP-gas cylinders of the U. S. Department of Transportation
(DOT Spec. 39).

1.5 Use propane fuel cylinders of not more than 75 cubic inches

(2-1/2 pounds nominal water capacity) and connect to cylinder
valve outlet connection No. 600 as specified in the
Compressed Gas Associations Limited Standard Cylinder Valve
Outlet Connection for propane-small valve series.

2.1 Grasp heater model by cylinder and hold wire stand with other

hand. Slide mounting clip on back of heater onto chrome
plated wire stand. Fig. 1 and 2.

2.2 Push igniter lead onto end of Sparklite Igniter on Model

MH12CS-Figure 2.

2.3 Make sure wire stand is on a flat surface in the outdoors. See

paragraph 5 for additional assembly procedure.

2.4

Never touch heater while in operation to avoid injury.
Move heater by grasping the propane cylinder carefully.

2.5 Read pages 3 and 4 before lighting heater.

Figure 1

Figure 2