Hampton Direct H25-NG1 Manual Do Utilizador

Hampton

®

 H25-1 Direct Vent Freestanding Gas Stove

39

1)  Unplug or disconnect power source to 

stove.

2)  Remove the rear access panel on the back 

of the stove by removing the 2 screws under 
the rear panel, then lift off the 2 screws at 
the top. Take care not to cut wires when 
lowering the panel.

If your fan requires maintenance or replace-
ment, access to the fan is through the rear 
access panel on the back of the unit.  NOTE: 
the unit MUST NOT be operated without 
the fan access panel securely in place and 
correctly sealed.

Conduct an inspection of the venting system 
semi-annually. Recommended areas to inspect 
as follows:

1)  Check the Venting System for corrosion in 

areas that are exposed to the elements. 
These will appear as rust spots or streaks, 
and in extreme cases, holes. These com-
ponents should be replaced immediately.

2)  Remove the Cap, and shine a fl ashlight 

down the Vent. Remove any bird nests, or 
other foreign material.

3)  Check for evidences of excessive condensa-

tion, such as water droplets forming in the 
inner liner, and subsequently dripping out the 
joints, Continuous condensation can cause 
corrosion of caps, pipe, and fi ttings. It may 
be caused by having excessive lateral runs, 
too many elbows, and exterior portions of the 
system being exposed to cold weather.

4)  Inspect joints, to verify that no pipe sections 

or fi ttings have been disturbed, and conse-
quently loosened. Also check mechanical 
supports such as Wall Straps, or plumbers' 
tape for rigidity.

5)  Verify proper operation after servicing.

The unit should never be used with broken logs. 
Turn off the gas valve and allow the unit to cool 
before opening door to carefully remove the 
logs. The pilot light generates enough heat to 
burn someone. If for any reason a log should 
need replacement, you must use the proper 
replacement log. The position of these logs 
must be as shown in the diagram under Log 
Installation.  

Your  sove is supplied with high temperature, 5 
mm Neoceram ceramic glass that will withstand 
the highest heat that your unit will produce.  In 
the event that you break your glass by impact, 
purchase your replacement door from an au-
thorized Hampton

®

 dealer only, and follow our 

step-by-step instructions for replacement. 

1)  Lift off the Cast Top.

2)  Open the 2 latches of the Glass Front.

3)  Lift the Glass Front Assembly up.

4)  Remove the glass and replace with the new 

glass.

5)  Replace the door and Cast Top.

Replacement Part # 946-327 Glass