Hampton Direct H15-LP1 Manual Do Utilizador

40

Hampton

®

 H15-1 Direct Vent Freestanding Gas Stove

If your fan requires maintenance or replacement, 
access to the fan is through the rear access 
panel on the back of the unit.  

Conduct an inspection of the venting system 
semi-annually. Recommended areas to inspect 
as follows:

1)  Check the Venting System for corrosion in 

areas that are exposed to the elements. 
These will appear as rust spots or streaks, 
and in extreme cases, holes. These com-
ponents should be replaced immediately.

2)  Remove the Cap, and shine a fl ashlight 

down the Vent. Remove any bird nests, or 
other foreign material.

3)  Check for evidences of excessive condensa-

tion, such as water droplets forming in the 
inner liner, and subsequently dripping out the 
joints, Continuous condensation can cause 
corrosion of caps, pipe, and fi ttings. It may 
be caused by having excessive lateral runs, 
too many elbows, and exterior portions of the 
system being exposed to cold weather.

4)  Inspect joints, to verify that no pipe sections 

or fi ttings have been disturbed, and conse-
quently loosened. Also check mechanical 
supports such as Wall Straps, or plumbers' 
tape for rigidity.

5)  Verify proper operation after servicing.

The unit should never be used with broken logs. 
Turn off the gas valve and allow the unit to cool 
before opening door to carefully remove the 
logs. The pilot light generates enough heat to 
burn someone. If for any reason a log should 
need replacement, you must use the proper 
replacement log. The position of these logs 
must be as shown in the diagram under Log 
Installation.  

Your  stove is supplied with high temperature, 5 
mm Neoceram ceramic glass that will withstand 
the highest heat that your unit will produce.  In 
the event that you break your glass by impact, 
purchase your replacement door from an au-
thorized Hampton

®

 dealer only, and follow our 

step-by-step instructions for replacement. 

1)  Lift off Cast Top.

2)  Open the 2 latches to remove Glass Front.  

Angle out and then lift, same as Cast 
Front.

3)  Remove glass and replace with  new 

glass.

4) Re-install 

Cast 

Top.