Daewoo DSB-071LH Manual Do Utilizador

11

1. Remove the screw holding on the connection cover.

Remove the connection cover on the outdoor unit to
access the connection area.

3. Connect the wires to the housing and terminals on

the Control board individually according to the out-
door unit Connection.

The Indoor/Outdoor wire is used to supply AC from the Indoor unit to the Outdoor unit. To install the indoor/outdoor wire,
follow the procedures below.

2. Route the indoor/outdoor wire into the opening on

the outdoor unit and through the wire holder. To con-
nect to the wire holder, loosen the screw on the wire
holder, insert the wires through, then tighten the
screw.
Use the wire as shown below:

Housing & Terminals on the 

outdoor unit

Housing B

GRAY

color of wires

color of wires

BLACK

GRAY

BLACK

Housing A

Black

Brown

Yellow/

Green

Blue

Black

Brown

Yellow/

Green

Blue

Blue

Blue

Y

1

L

2

Terminals

Housing & Terminals on the 

indoor unit

Main PCB

Terminals

Y 

1

L

2

4. To connect wires, loosen the screw in the Terminal

Block and insert the correct wires like following fig-
ure. Connect the Brown wire to the “L” connection,
Yellow/Green wire to the “

” connection, the Blue

wire to “Y” connection, the Blue wire to “1” connec-
tion and the Black wire to “2” connection. Insert
Housing “A” and Housing “B” to connection.

The used connection cable connected to indoor and
outdoor unit must be ; 

1) H07RN-F  3G1.5mm

2

(NOT INCLUDED)

2) H07RN-F  2G1.5mm

2

(NOT INCLUDED)

3) UL2464 AWG22  2G0.75mm

2

(INCLUDED IN SET)

• Make sure the Indoor unit’s AC cord is not connected to

AC power when connecting the indoor/outdoor wire.

• When connecting wires, make sure they are fully insert-

ed and minimum copper wire is exposed. If they are
not, shorting, overheating, no operation, etc. may occur.

• Be sure to comply with local codes on running a wire

from the indoor to the outdoor unit.

Brown

Yellow/Green

Blue

Blue

Black

Connection
Cover