Daewoo DSB-122L Manual Do Utilizador

9

1. Insert the at-

tached AC plug
into a pronged
220V AC outlet.

AC Outlet
and Plug

• Never connect the AC line cord plug to other than the

specified voltage (220V).

• Use the attached power cord only.
• The new air conditioner system should be on it’s own

220V circuit. Contact your local electrical installer for in-
stallation.

The outdoor unit is connected to the indoor unit through the AC connecting wire or connection cord. To connect the in-
door unit to AC, follow the procedures below:

1. Remove the left and right side to open the indoor

cover upward.

•  Please remove and insert 

• 

the indoor cover by two hands.

2. Store the remote controller.

(Remove it when using)

3. Press the left and right side to close the indoor cover.

To store the remote controller, follow the procedures below:

Plug into 220V AC Outlet.

After the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation,
follow the procedures below:

1. Open the indoor unit’s cover and make sure the

EMERGENCY/REMOTE switch is set to the REMOTE
position; this will allow the unit to operate with the re-
mote controller.

EMERGENCY/REMOTE Switch

2. Press the ON/OFF button on the remote controller to

turn on the unit. The On LED will light on the indoor
unit and “ON” will light in the remote display.
To select the various modes
and settings, read the fol-
lowing pages.

EMERGENCY

REMOTE

• After turning the indoor unit on and setting it for air con-

ditioner operation, the compressor (outdoor unit) will
not come on for three minutes. This is a feature that
will protect the compressor from damage due to quick
start and stops. 

 DSB-122L/122LH(영어)  01.8.17 5:27 PM  페이지9