Friedrich WE16 Manual Do Utilizador

13

920-007-12

These instructions are provided for installation of WallMaster air 

conditioner chassis models into thru-the-wall sleeves. This chassis 
has been UL approved with the sleeve listed on the serial nameplate 
of this chassis. Important warranty information is provided on pages 

17 and 18.  Keep these instructions in a convenient location for any 

warranty service that may be required.

STEP 1  Check the sleeve to be certain it has been correctly installed 

in the wall. Remove the corrugated front panel on the WSC 
SLEEVE. Remove the rear WEATHER PANEL. Reverse 
grille. Place lower edge into sleeve tab (Friedrich logo facing 
out). Align slots with screw holes. Secure grille with screws.  

 

A. 

Check the anchor screws.  There should be four 

(4) in the WSC SLEEVE (two in each side).

 

B. 

Determine if the sleeve has a downward slope, 

to the outside, of ½ bubble on a level. See 
page 10 for further details.

 

C. 

Check to be sure the sleeve has been sealed 

around all edges with an industrial type 
caulk ing on both the outside and in side to 
prevent rain entry.