Heartland 2603 Manual Do Utilizador

29

a good seal. 
If  the  gasket  comes  loose  but  is  still  usable,  it  can  be 

reseated using a good high temperature silicon. Replacement 

gasketing and adhesive can be ordered from Heartland or 

your dealer.
Gasketing  is  sold  by  the  foot.  Refer  to  the  gasket  listing 

below.

SweetHeart:
oven door - 4 ft #6387 rope gasket  

                                                                             

 

 

 

ash door - 3 ft #1710 rope gasket                         

 

   

              

key plate gasket - 5 ft #1711 rope gasket

Oval:
oven door - 4 ft #6387 rope gasket           

 

 

 

                   

 

ash door - 4 ft #1710 rope gasket             

 

 

   

 

key plate gasket - 6 ft #1711 rope gasket
   

 

Periodic  cleaning  and  inspection  of  the  firebox  is 

recommended.
On the SweetHeart and Oval cookstove there is a gasket on 

the top under the keyplate. This gasket should be inspected 

and replaced if it fails to seal. 
Check for condition of side castings (Oval only) and smooth 

operation of wood grate. 

 and may be sealed 

with stove cement.

will prolong the life of these parts by:
1. 
2. 
3. 

The temperature registered by the oven door thermometer 

may not necessarily correspond with the reading taken 

with the thermometer inside the oven. For accurate oven 

temperatures, refer to the interior oven thermometer. 

An adjustment* can be made to the oven door thermometer 

to allow a more representative temperature reading 

(most thermometers are adjusted to provide accurate 

readings in the 300F to 400F (150C to 205C) temperature 

range).  After the adjustment, the low and high end of 

the temperature spectrum will not be accurate.  To make 

temperature adjustments please follow the instructions 

below:

* This adjustment may not be available on your unit.

 
1)  Begin by removing the screws on the inside oven door 

panel. Remove panel.

Rear view of Thermometer Figure 11

2) 

The back of the thermometer is exposed ready for 

3) 

thermometer, moving indicator needle to desired position. 

4)  Replace the oven door panel and screws.
5)  Re-test thermometer and adjust again if necessary.