Hughes AN4-074-DF Manual Do Utilizador

 

The fine elevation pointing tool (Figure 18) consists of a long 
elevation adjustment bolt with a clamp on one end and a flange on 
the other end. The clamp and flange attach to the Az/El cap as 
shown in Figure 18. 

Install the fine elevation pointing tool as follows:

1. Align the two clamp bolt holes with the holes at the base of 

the elevation cap.

2. Use a 1/2-in. wrench to install the elevation clamp bolt and 

nut.

3. Swing the flange so the two bolts on its wide side align with 

the installation holes on the Az/El cap.

4. Insert the flange bolts in the holes and use a 1/2-in. wrench to 

secure them using the flange bolt nuts.

Figure 18:  The fine elevation pointing tool

Flange

Elevation adjustment 
nuts (2). Do not remove.

Elevation 
adjustment 
bolt

Do not remove 
this nut and bolt.

Clamp

Clamp bolt with nut 
on opposite end

Flange bolts 

 

and nuts (2 sets)