Hughes AN4-074-DF Manual Do Utilizador
Chapter 3 • Installing the radio and antenna assemblies
1035567-0001 Revision A
25
Installing the radio
assembly on the feed
arm
assembly on the feed
arm
If the radio assembly is already attached to the feed arm, skip this
section and go to Connecting the feed arm to the antenna
reflector on page 26.
section and go to Connecting the feed arm to the antenna
reflector on page 26.
Follow these steps to install the radio assembly on the feed arm:
1. Place the O-ring in the circular depression in the square end
2. Align the square end of the radio assembly with the square
end of the feed arm so you can install the four M4 screws.
Install the lock washers on the screws. Use the Allen wrench
to install the M4 Allen screws, but do not fully tighten them.
Install the lock washers on the screws. Use the Allen wrench
to install the M4 Allen screws, but do not fully tighten them.
3. Align the bolt holes on the top of the transmitter with the bolt
holes on the bottom of the feed arm.
4. Install the 5/16-18 bolts in the aligned holes. Finger tighten
them; do not tighten them further at this time.
5. Use the Allen wrench to tighten the Allen screws.
Figure 23: Securing the O-ring
O-ring