Enviro 1200 Freestanding Manual Do Utilizador

35

Installation

1.  If  the  surround  panel  is  installed,  remove  it  by  lifting  the 

panel straight up then out.

2.  For  the  right  shroud,  twist  the  handle  on  the  air  control 

clockwise to remove it from the rod.

3.  Pull unit forward a few inches, if possible.
4.  The shrouds can be  removed one of two ways:

a.  For the first method, pull the inside edge of the shroud 

straight out, approximately 3⁄4” (2cm), in order to unhook 

the  shroud  from  unit.  Pull  the  shroud  out  through  the 

side. 

b.  For  the  second  method  (recommended  for  the  right 

shroud),  remove  the  two  (2)  T-20  screws  that  hold  the 

shroud to the unit (shown in Figure 43). Pull the shroud 

out through the side. 

5.  To  install  the  shroud,  follow  steps  1  through  4  in  reverse 

order. Ensure the shrouds are hooked behind both screws on 

either side.

1.  Remove  the  shroud  from  the  unit  (refer  to  “R

EMOVAL

  O

F

  T

HE

  S

HROUDS

  - 

I

NSERT

”)

2.  Remove the fan from the left shroud (refer to ”F

AN

 R

EMOVAL

 - I

NSERT

”)

3.  Unfasten the two (2) nuts that secure the plate to the shroud. The nuts 

should only be hand-tightened but a 

5

/

16

” wrench may be required.

4.  Remove the old plate and replace with a new decorative plate.
5.  Hand-tighten the two (2) nuts back into place.
6.  Re-install the fan into the left shroud.
7.  Re-install the shrouds onto the unit.