Honeywell MS-9200UDLS Manual Do Utilizador

Programming

96

MS-9200UDLS   PN 52750:A    11/04/05

Options available for the MS-9200UDLS include ACS Series, Graphic and LCD 
annunciators, printer connection for acquiring hardcopy printouts of panel data and PC 
(Personal Computer) connection for uploading and downloading panel data.  

Pressing 3 while viewing Programming Screen #3 will display the following screen: 

Note that PR4800 in the display indicates that a supervised printer, configured for 4800 
baud, has been previously programmed into the system.

Pressing 1 while viewing the Options Screen will cause the control panel to display 
the following screens: 

A Terminal Mode annunciator* and ACS Mode annunciator can be installed in the 
MS-9200UDLS system.  To enable any of these devices, press the number 
corresponding to the selected device shown in Annunciator Screen #1 so that Yes 
appears in the display to the right of the device.  Each press of the corresponding 
number key will cause the display to toggle between Enabled Yes and Enabled No.

Notes: 

1. *The LCD-80F is a Terminal Mode annunciator.  To enable the MS-9200UDLS 

for LCD-80F operation, program Term Enabled to Yes.

2. The Terminal Mode annunciator (LCD-80F) and the Printer/PC use the same 

TB8 terminal block on the MS-9200UDLS main circuit board.  Only one device 
can be connected at one time, therefore, programming Term Enabled to Yes will 
disable any Printer/PC communications.

    PROGRAMMING
1=HISTORY
2=WALKTEST
3=OPTION MODULES

Programming Screen #3

   OPTION MODULES
1=ANNUNCIATORS/UDACT
2=ONBOARD DACT
3=PRINTER/PC  PR4800

    ANNUNCIATOR
1=TERM ENABLED 

YES

2=ACS ENABLED    YES
3=UDACT          YES

    ANNUNCIATOR
1=ACS INSTALLED