Honeywell MS-9200UDLSE Manual Do Utilizador

Operating Instructions

Read Status

142

MS-9200UDLS PN 52750:A 11/04/05

Pressing the down arrow key, while viewing the screen shown above, will allow the
operator to view additional programming information about the selected device, such
as:

• Enable/Disable Status
• Device Type
• Alarm Verification On/Off (for detectors)
• Walktest Yes/No
• PAS (Positive Alarm Sequence) Yes/No (for detectors only)
• Pre-Signal Yes/No (for detectors and monitor modules)
• Zone Assignments (five maximum)
• Chamber Reading
• Adjective/Noun descriptor
• Silenceable Yes/No (for control modules)

4.22.2 Zones

Pressing 2 while viewing Read Status Screen #1 will cause the following screens to be
displayed:

From the preceding screens, the control panel operator can view:

• Zones Installed - all software zones programmed into the system (99 maximum)
• Zones Enabled - all software zones that are enabled
• Zones Disabled - all software zones that have been disabled
• Special Purpose - on or off programming for Special Purpose Zones 97 reserved

for PAS, 98 reserved for Pre-signal and 99 reserved for Two Stage

• Zone Type - the Type assigned to each installed zone (default is Alarm)
• Zone Message - the Message assigned to each installed zone

READ STATUS
1=SYSTEM POINT
2=ZONES
3=POWER

Read Status Screen #1

ZONES
1=ZONES INSTALLED
2=ZONES ENABLED
3=ZONES DISABLED

Zones Screen #1

ZONES
1=SPECIAL PURPOSE
2=ZONE TYPE
3=ZONE MESSAGE

Zones Screen #2