Lightolier 83ED17 Folheto

8307U

ED17 Open/Square Lytespot
for Unprotected Lamp

8317U

ED17 Enclosed/Round Lytespot
for Unprotected Lamp

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:83ED17

C0104

Page 1 of 2

INSTRUCTIONS FOR ATTACHING 83ED17R SERIES REFLECTORS TO

POWERARC MODULAR ED17 LYTESPOT (ROUND OR SQUARE FRONT)

LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720

INSTRUCTIONS FOR ATTACHING 83ED17R SERIES
REFLECTORS TO A PowerArc ED17 SPOT:
(See chart below for compatible luminaires)

NOTE: Reflectors must be installed prior to lamps. After
reflector is installed, see IS:83S for installation, lamp-
ing, and operating instructions.

1. Orienting LABEL in the UP position, hold REFLECTOR

by the LIP and push into REFLECTOR CUP until
REFLECTOR SPRINGS engage. (See FIG. 6 and 7).

2. Rotate REFLECTOR clockwise until the REFLECTOR

SPRINGS hit the ROTATION STOPS on the REFLEC-
TOR CUP. (See FIG. 7)

To remove REFLECTOR:Remove lamp, rotate
REFLECTOR counterclockwise until REFLECTOR
SPRINGS snap into REMOVAL SLOTS. Pull REFLEC-
TOR out of REFLECTOR CUP. (See Fig. 7)

COMPATIBLE LUMINAIRES

Cat. No. Product Group

Description

8307

Lytespan Track

ED17 Open/Square Lytespot
for Protected Lamp

8317

ED17 Enclosed/Round Lytespot
for Protected Lamp

REMOVAL
SLOT

ROTATION
STOP

REFLECTOR
SPRING

REFLECTOR
LIP

REFLECTOR
SPRINGS

REFLECTOR

REFLECTOR
CUP

ED17
SPOT

REFLECTOR

LABEL

FIG. 6

FIG. 7

(UP POSITION)