Cooper Lighting MD6xT4 Manual Do Utilizador
704530 Rev. A
- 1 - Customer First Center · 1121 Highway 74 South · Peachtree City, GA 30269
Portfolio
®
Installation Instructions for MD6xT6, MD6xT4, MD6CPxT6 and MD6CPxT4
Commercial Recessed Housings
Commercial Recessed Housings
CAUTION: To avoid possible electrical shock, be sure that power supply is turned off before installing or servicing this
fixture.
CAUTION: Metal halide lamps have arc tubes that operate at extremely high temperatures and may shatter unexpectedly
as a result of misapplication, system failure or internal factors. This violent failure could cause extremely hot glass
and lamp parts to discharge into the surrounding environment, creating a risk of personal injury, fire or property
damage. Therefore, it is incumbent on the user to use common sense and good judgment in anticipation of these
potential violent failures. Never use or operate this fixture without safety glass or lens properly installed and secured in
place.
Reduction of Risk
The potential of violent failure can be significantly reduced by relamping at or before the rated end of life. In applications
where the lamps burn continuously, the lamps should be turned off for a period of 15 minutes at least once per week
which will cause lamps nearing their end of life to fail passively upon relighting. Careful adherence to the above
precautions may not eliminate all possible risks associated with the use of Metal Halide lamps, but it will reduce the
likelihood of personal injury or property damage.
Rough-In Mounting
•
This fixture should be supported by main runners or
other structure that is capable of supporting fixture
weight of 17lbs.
other structure that is capable of supporting fixture
weight of 17lbs.
•
The junction box will accept both ½” and ¾” trade size
metal conduit.
metal conduit.
•
Review fixture labeling to make sure it is rated for the
voltage installation being used.
voltage installation being used.
•
The housing is designed for installation where it will
not come in contact with insulation. Thermal insulation
must be kept a minimum of three inches (3”) away
from the housing sides, top and junction box.
not come in contact with insulation. Thermal insulation
must be kept a minimum of three inches (3”) away
from the housing sides, top and junction box.
•
This housing/trim is designed to be used with T6/T4.5
Ceramic Metal Halide lamps for the specified wattages
only. These lamps can cause serious skin burn and
eye inflammation from shortwave ultraviolet radiation if the envelope of the lamp is broken or punctured.
Ceramic Metal Halide lamps for the specified wattages
only. These lamps can cause serious skin burn and
eye inflammation from shortwave ultraviolet radiation if the envelope of the lamp is broken or punctured.
Risk Of Fire
Supply conductors (power
wires) connecting the fixture
must be rated minimum
90°C. If uncertain, consult an
electrician.
Supply conductors (power
wires) connecting the fixture
must be rated minimum
90°C. If uncertain, consult an
electrician.
Risk Of Electrical Shock
Disconnect power at fuse or
circuit
Disconnect power at fuse or
circuit
breaker
before
installing or servicing.
Risk Of Fire.
Do not install insulation
within 3 inches (76 mm) of
any part of the fixture or in a
way that may entrap heat.
Do not install insulation
within 3 inches (76 mm) of
any part of the fixture or in a
way that may entrap heat.