Cooper Lighting P2R Manual Do Utilizador

Cover plate

1/4-20 x4"

(2x)

Exploded view and part call-out

Hex bolt

Canopy

(2x)

Wiring the fixture

. Replace canopy and secure using both set screws.

(2x)

Set screw

Fixture head

#8-32 x3/8"

assembly

1. Remove both 1/4-20 x4 hex bolts from bottom of pendant.

2. Remove both #8-32 x3/8" set screws and allow canopy to

slide down pendant.

3. Run wires from J-box into pendant, ensure there is enough

wire to reach cover plate.

4. Using appropriate fasteners, secure fixture to ceiling. Use

additional bracing around J-box to support fixture.

Aiming the fixture

Attention:

Large fixtures require additional bracing/structure

around J-box to support fixture.

Secure cover plate

1/4-20 x4

(2x)

Hex bolts

properly matched

Slide fixture assembly onto pendant and secure with both

Attach appropriate wires and ensure all connections are

1/4-20 x4 hex bolts.

Cover plate

1. To aim fixtures, loosen both #10-32 end screws on one

fixture. When both indicators are lined up, the slope of the

lens face is 40-degrees. Each subsequent notch is an

additional +/- 10-degrees.

2. When fixture head is rotated to the desired angle, retighten

end screws to secure the position.

3. Repeat for second fixture head.

Fixture head

indicator

Yoke arm

#10-32

End screw

Mounting pendant to ceiling

Cover plate

#8-32 x3/8"

(by others)

J-box

3/8" fasteners

(by others)

Canopy

Set screw

(2x)

1/4-20 x4

Hex bolts

(2x)

These installation instructions are valid with the above Ametrix styles.

Sheet 1 of 3

that all sources of power are turned off. All

Visor and Non-Visor

Warning

performed by a certified electrician.

: Before starting any work ensure

work must meet local/national codes and be

Do not

mount fixtures vertically.

Installation Instructions

Vault

C-Scroll

Roundel

Large, INDOOR

P2R

(Pendant, 2-way, Remote ballast)

ADY071471 REV A(ECN070347)