Cooper Lighting Indoor Lighting Manual Do Utilizador

Warning

: Before starting any work ensure

that all sources of power are turned off. All

work must meet local/national codes and be

performed by a certified electrician. Do not

mount fixtures vertically.

Installation Instructions

Vault

C-Scroll

Roundel

These installation instructions are valid with the above Ametrix styles.

Sheet 1 of 3

Large, INDOOR

P1R

(Pendant, 1-way, Remote ballast)

Visor and Non-Visor

ADY071470 REV A(ECN070347)

Securing fixture to pendant

1. Loosen #6-32x 3/8" Pan head screws and allow canopy to slide

down pendant.

2. Feed wires from J-box through wire ways in mounting plate

and secure fixture to bracing around J-box.

3. Attach appropriate wires and ensure all connections are

properly matched.

4. Replace canopy and secure with both #6-32 x3/8" Pan head

screws.

#6-32 x 3/8"

Pan head screws

(2x)

Appropriate

fasteners

(by others)

(4x)

Canopy

J-box

(by others)

Use additional bracing

around J-box to support

fixture.

1/4-20 x 3/4"

Hex cap screw

(2x)

End screw

(2x)

#6-32 x 1/4"

Flat head screw

End cap

1. Begin by removing end screw, #6-32 x 1/4" Flat head screw

and end cap from one side of Yoke and remove fixture head.

2. Mount yoke to pendant with both 1/4-20 Hex cap screws.

3. Feed fixture wire through connector in pendant up through

mounting plate and reattach fixture head to yoke.

Wire connector

Yoke

Mounting plate

Fixture wire

#10-32

End screw

(2x)

#10-32 x3/8"

Pan head screw

(2x)

Canopy

Mounting plate

1/4-20 x3/4"

Hex cap screw

(2x)

Appropriate fasteners

(by others)

(2x)

Exploded view and part call-out

Mounting and wiring fixture

Aiming the fixture

Attention:

Large fixtures require additional bracing/structure

around J-box to support fixture..

Wire ways

#10-32

End Screw

Fixture head

indicator

Yoke arm

indicator

1. To aim fixtures, loosen both #10-32 end screws on

fixture. When both indicators are lined up, the slope of the

lens face is 40-degrees. Each subsequent notch is an

additional +/- 10-degrees.

2. When fixture head is rotated to the desired angle, retighten

end screws to secure the position.