Chauvet SCAN LED 100 Manual Do Utilizador

 
4. Operating Instructions 

8 

11/19/2010 11:07 AM  

 

 

 

 

 

The Intimidator™ Scan LED 100

 

fixture uses 6 DMX channels. In this DMX configuration/personality, 

the highest channel that the fixture may be set to in order to function properly is 507. Any address 
higher than this will prevent access to all of the channels, while in this mode; however, if you desire to 
use one of the other DMX channels configurations (personalities), please consider the total DMX 
channels when selecting a DMX address. 

If this is your first time using DMX, we recommend reading the “DMX Primer” section in the 
“Appendix”. 

 

 

 

 

 

 

 

This is the operating mode which will allow for control with an external DMX controller. You must 
set the starting address for this mode. If this is your first time using DMX, then it is recommended 
that you refer to the “DMX Primer” section in the “Appendix” of this manual. 
 

1. 

Plug a DMX controller into the fixture in a daisy chain configuration.

 

2. 

Using the DIP switches, select the starting address (001~507).

 

 

 

 

 

 

 

This mode allows a single unit, the master, to operate in one of the standalone modes, while one 

or more fixtures, slaves, synchronize their responses to the master. 

Master: 

The master fixture may be set in any of the STANDALONE modes listed in this user manual. 
This must be placed first in the DMX daisy chain. 

Slave: 

1. 

Turn off all DIP switches and daisy chain from the output of the master.