Dometic 3000 Series Manual Do Utilizador

9

9. Water leaking from Water

Valve.

10. Water will not enter toilet bowl

when the Flush Handle  is

raised to add water.

11. Water Level Switch has no

effect on water level in low or

high positions.

12. Water will not shut off –

toilet overflows.

13. Flush ball will not open with

Mode Switch in "Service"

position.

a. Water Valve body cracked due to

freeze damage.

b. Water line connection is loose or

not seated properly.

c. Defective Water Valve.

d. Stripped threads.

a. Loose electrical connections or

defective Flush Switch.

a. Defective Water Level Switch or

Control Module.

a. Dirt or debris lodged in Water Valve

seal.

b. Defective Water Valve.

c. Defective Control Module.

a. Defective Mode Switch or Control

Module.

a. Replace Water Valve.

b. Insure that threads are not

cross-threaded and tighten.

c. Replace Water Valve.

d. Replace Water Valve.

a. See Electrical Troubleshooting

section.

a. Replace Control Module.

a. Disassemble and clean Water

Valve.

b. Replace Water Valve.

c. Replace Control Module.

a. Replace Control Module.

In the event of an electrical failure, the flush ball of the toilet can be manually opened to clear the bowl. We recommend
using a long-neck screwdriver or 7/16-in. socket for the operation shown below. NEVER PRY OPEN THE FLUSH BALL
FROM INSIDE THE TOILET BOWL. Damage to the flush ball and bowl seals may result.

1. Remove access cover from top of china toilet. Place

Mode Switch in the "Manual Override" position. This
disconnects flush valve motor brake from electrical
circuit.

2. Locate hole on side of china toilet. This allows access

to the flush valve motor drive arm.

3. Insert screwdriver or 7/16-in. socket through access

hole and onto hex head.

4. Turn screwdriver or socket counter-clockwise. This

will open flush ball and allow bowl contents to clear.
After bowl is clear, turn screwdriver or socket clockwise
to return flush ball to original position.

NOTES:
Water will not enter the toilet bowl during manual flush
operation.
Place Mode Switch in the "Normal" position before
returning to automatic operation.