Honeywell IFS-2600 Manual Do Utilizador
Page 28
IFS-2600 Installation & Programming Manual
P/N 10069 ECN08-0066
OUTPUT RELAY OPTIONS
Optional Relays can be programmed to simulate: -
Isolate Relay
ACF Output
Brigade Relay #1
Brigade Relay #2
Fault Relay
Mains Fail Relay
General Alarm Relay
Bell Output
Door Holder Relay
Door Switch
Reset
Or Can Be Used To:
"MAP AND"
Up to 5 Zones in Alarm
"MAP OR"
Up to 5 Zones in Alarm
“MAP FAULT”
Up to 5 Zones in Fault
“MAP ISOLATE”
Up to 5 Zones in Isolate
“MAP ISO/FAULT”
Up to 5 Zones in Isolate/Fault
DEFAULT SETTINGS
ACF OUTPUT
NON-LATCHING, NORMALLY DE-ENERGISED
ALARM VERIFICATION (AVF)
3 MINUTES
TIME
1/1/11 11:11
ZONE TYPES
STANDARD LATCH 2S
ZONE OUTPUT CONFIG
I-B-G-A-BR1 & BR2
RELAY MAPPING
MAP -OR-, MAPPING = 1 TO 1
IE: RELAY 1 = ZONE 1, RELAY 2 = ZONE 2.............
IE: RELAY 1 = ZONE 1, RELAY 2 = ZONE 2.............
The 2600 PANEL is self-configuring on power-up therefore it is not necessary to program the number
of relay boards.
Zone expansion boards fitted must have the correct jumper selected.
of relay boards.
Zone expansion boards fitted must have the correct jumper selected.