American Standard 7272.221 Manual Do Utilizador

LOCK NUT

STEEL WASHER

M 9 6 8 4 8 7

SINGLE AND DUAL CONTROL
LABORATORY FITTINGS

SINGLE CONTROL

LABORATORY FITTINGS

DUAL CONTROL

LABORATORY FITTINGS

For vandal resistant fitting only, a pin hole will be need to be drilled into the deck offset from the mounting shank hole.
Note: For vandal resistant models it is important to obtain the rough-in drawing for the particular model. The
drawing illustrates exact size and positioning of the offset hole. Drill a 1/4" (6mm) dia. hole 3/8" (10mm) deep
in mounting surface, per roughing-in dimensions for vandal resistant pin.

For vandal resistant fitting apply

putty

to underside of fitting base to assure a good seal and level fit.

When installing a vandal resistant fitting, align pin with pin hole in mounting surface.

For standard fitting, assemble rubber washer onto body shank.

Place body shank through hole in deck and assemble steel washer and lock nut. Tighten securely.

Pipe to correct service to complete installation.

After installation is complete turn service on and check all connections for leaks.

TOOLS AND SUPPLIES REQUIRED

Adjustable Wrench

Teflon Tape

Drill

Plumbers' Putty or
Caulking

FITTING

BASE

PUTTY

BODY
SHANK

FITTING

BASE

LOCK NUT

STEEL WASHER

Channel Locks

7272.220

7272.201

7272.221
7272.221VR

7272.120
7272.121
7272.121VR

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR

WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,

ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A

COARSE SURFACE.

RUBBER WASHER

(NOT USED ON

VR FITTINGS)

RUBBER WASHER
(NOT USED ON
VR FITTINGS)

VANDAL RESISTANT PIN
ON VANDAL RESISTANT
FITTINGS ONLY

OFFSET HOLE FOR
VANDAL RESISTANT PIN

VANDAL RESISTANT PIN
ON VANDAL RESISTANT
FITTINGS ONLY

OFFSET HOLE FOR
VANDAL RESISTANT PIN

PUTTY

IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO FITTING INSTALLATION.