Panasonic SC-HTB500 Manual Do Utilizador
10
Assembling the unit
Refer to the following when placing this unit on a table or in a rack. For wall mount, refer to the
installation instructions. (> 23)
installation instructions. (> 23)
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
≥Keep the screws out of reach of children to prevent swallowing.
≥Keep the screws out of reach of children to prevent swallowing.
≥ Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1
On the rear of the unit:
Place the wall mount bracket by aligning the holes in the wall mount bracket
with the projecting parts A.
with the projecting parts A.
2
Screw the wall mount bracket firmly into place.
≥ Screw tightening torque: 80 N0cm to 120 N0cm.
≥ Repeat the steps above when installing the second wall mount bracket.
≥ Repeat the steps above when installing the second wall mount bracket.
3
Thread a cord (not supplied) through each wall mount bracket.
≥ Make sure to use a cord which is capable of
supporting over 20 kg.
A Rear of this unit
B Fall prevention
B Fall prevention
cord (not supplied)
4
After all the necessary connections are finished. (> 11)
Place the unit in the desired position and attach each cord onto the rack or
table.
≥ Attach each cord to a different screw eye.
≥ Make sure that there is no more than a 3 cm slack.
A This unit
B Fall prevention cord (not supplied)
C Rack or table
D Screw eye (not supplied)
≥ Make sure that there is no more than a 3 cm slack.
A This unit
B Fall prevention cord (not supplied)
C Rack or table
D Screw eye (not supplied)
≥ Attach at a position capable of supporting over
20 kg.
Professional installation is required.
The installation should never be done by any other than a qualified installation specialist.
The installation should never be done by any other than a qualified installation specialist.
To prevent the unit from falling
E.g.,
SCHTB500EGGNGS_RQTX1185-B.book Page 10 Wednesday, July 7, 2010 5:18 PM