ONKYO SKM-550S Manual Do Utilizador

 

39

 

While the automatic speaker setup is in progress, one of 
the following error messages may appear:

 

This message appears if there’s too much background 
noise and the measurements cannot be performed prop-
erly. Remove the source of the noise and try again.

 

This message appears if one of the speaker-related errors 
below occurs.
• One of the front speakers has not been detected.

• One of the surround speakers has not been detected.

• The surround back speakers have been detected but 

the surround speakers haven’t.

• The right surround back speaker has been detected but 

the left surround back speaker hasn’t.

• The number of speakers detected on the second or 

third measurment was different to the number detected 
on the first measurement.

 

This message appears if saving fails.

 

In some situations, the measurements taken by the auto-
matic speaker setup may not provide usable results. If 
running the speaker setup a second time still doesn’t pro-
vide usable results, you’ll have to set the speaker settings 
manually (see pages 56–60).

 

If you’re using a powered subwoofer, because it outputs 
very low-frequency sound and its position is usually low 
down, it may not be detected by the automatic speaker 
setup. In this case, increase the subwoofer’s volume, set 
it to its highest crossover frequency, and then try running 
the automatic speaker setup again. Note that if the vol-
ume is set too high and the sound distorts, it may not be 
detected, so use an appropriate volume level. If the sub-
woofer has a low-pass filter switch, set it to Off or Direct. 
Refer to your subwoofer’s instruction manual for details.

Press the [ENTER] button.
Make sure speakers that cannot be 
detected are connected properly.

HT-SR800_En.book Page 39 Tuesday, January 30, 2007 11:09 AM