ONKYO HT-R340 Manual Do Utilizador

 

37

 

The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.

To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control-
ler’s [ON/STANDBY] button. The AV receiver will enter Standby mode. To prevent 
any loud surprises the next time you turn on the AV receiver, always turn down the 
volume before turning it off.

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the 
very first time. These settings only need to be made once.

■ Have you connected a component to a digital audio input?

If you have, see “Assigning Digital Inputs to Input Sources” on 
page 38.

■ Have you connected an Onkyo MD recorder, CD recorder, 

or RI Dock?
If you have, see “Changing the Input Display” on page 38.

CD recorder, MD recorder

Testing the speakers
To test that all of the speakers are working properly, press the remote controller’s [TEST TONE] button. 
The test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn 
off the test tone, press the [TEST TONE] button again.
• If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display, 

you may have wired the speakers incorrectly and you should check your connections (see page 21).

• If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the 

speaker settings incorrectly (see page 55).

HT-S3100_3105_En.book Page 37 Friday, February 1, 2008 9:14 AM