ONKYO 29344937 Manual Do Utilizador

39

With 

u (Remote Interactive), you can use the following special functions:

■ Auto Power On/Standby

When you start playback on a component connected via 

u, if the AV receiver is on Standby, it will automatically 

turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all 
components connected via 

u will also go on Standby.

■ Direct Change

When playback is started on a component connected via 

u, the AV receiver automatically selects that component 

as the input source.

■ Remote Control

You can use the AV receiver’s remote controller to control your other 

u-capable Onkyo components. You must 

enter the appropriate remote control code first (see page 85). And remember to point the remote controller at the AV 
receiver and not the other component.

Notes:
• Use only 

u cables for u connections. u cables 

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two 

u jacks. You can 

connect either one to the AV receiver. The other jack 
is for connecting additional 

u-capable 

components.

• Connect only Onkyo components to 

u jacks. 

Connecting other manufacturer’s components may 
cause a malfunction.

• Some components may not support all 

u functions. 

Refer to the manuals supplied with your other Onkyo 
components.

• While Zone 2 is on, the Auto Power On/Standby and 

Direct Change 

u functions do not work.

• Before connecting the power cord, connect all your speakers and AV components.
• Plug the end of the power cord into a suitable wall outlet.
• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment 

on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

u Components

Step 1:  Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2:  Make the necessary 

u connections (see illustration below).

Step 3: If you’re using an MD, CDR, or RI DOCK component, change the Input Display (see page 45).