ONKYO 29344937 Manual Do Utilizador
43
If you connect a component to a digital audio input, you
must assign that input to an input selector. For example,
if you connect your CD player to OPTICAL IN 1, you
must assign OPTICAL IN 1 to the CD input selector.
These are the default assignments.
must assign that input to an input selector. For example,
if you connect your CD player to OPTICAL IN 1, you
must assign OPTICAL IN 1 to the CD input selector.
These are the default assignments.
Notes:
• When an HDMI IN is assigned to an input selector in
• When an HDMI IN is assigned to an input selector in
“HDMI Input Setup” on page 41, this input
assignment is automatically set to the same HDMI IN.
And in addition to the usual inputs (e.g., COAX1,
COAX2, etc.), you can also select HDMI inputs.
assignment is automatically set to the same HDMI IN.
And in addition to the usual inputs (e.g., COAX1,
COAX2, etc.), you can also select HDMI inputs.
• If you connect an input component (such as UP-A1
series Dock that seated iPod or iPhone) to the
UNIVERSAL PORT jack, you cannot assign any input
to PORT selector.
UNIVERSAL PORT jack, you cannot assign any input
to PORT selector.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
and [ENTER] button.
Digital Input Setup
Input selector
Default assignment
DVD/BD
COAX1
VCR/DVR
- - - - -
CBL/SAT
COAX2
AUX
- - - - -
TV/TAPE
OPT1
CD
OPT2
PORT
- - - - -
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
followed by the [SETUP] button.
2
Use the Up and Down [
q]/[w]
buttons to select “1. Input
Assign”, and then press
[ENTER].
Assign”, and then press
[ENTER].
SETUP
RECEIVER
qwer
ENTER
3
Use the Up and Down [
q]/[w]
buttons to select “1-3. Digital”,
and then press [ENTER].
and then press [ENTER].
4
Use the Up and Down [
q]/[w]
buttons to select an input selector,
and then use the Left and Right
[
and then use the Left and Right
[
e]/[r] buttons to select:
COAX1: Select if the component is
connected to DIGITAL IN
COAXIAL 1.
COAXIAL 1.
COAX2: Select if the component is
connected to DIGITAL IN
COAXIAL 2.
COAXIAL 2.
OPT1: Select if the component is
connected to DIGITAL IN
OPTICAL 1.
OPTICAL 1.
OPT2: Select if the component is
connected to DIGITAL IN
OPTICAL 2.
OPTICAL 2.
- - - - -: Select if the component is
connected to an analog input.
Notes:
• Press the [ENTER] button when you
• Press the [ENTER] button when you
do not use the signal of audio from
the HDMI IN. The “ ” mark is
displayed like “COAX1 ”.
the HDMI IN. The “ ” mark is
displayed like “COAX1 ”.
• For the input selector that you want to
listen the analog audio, set to “- - - - -”
in the Digital Audio Input setting and
HDMI Input setting (see page 41).
in the Digital Audio Input setting and
HDMI Input setting (see page 41).
5
Press the [SETUP] button.
Setup closes.
Setup closes.
*
*