ONKYO 29344937 Manual Do Utilizador

82

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust 
the volume for Zone 2.

Notes:
• Only analog input sources are output by Zone 2. 

Digital input sources are not output. If no sound is 
heard when an input source is selected, check to make 
sure it’s connected to an analog input.

• While Zone 2 is on, the Auto Power On/Standby and 

Direct Change 

u functions do not work.

• While Powered Zone 2 is being used, listening modes 

that require surround back or front high speakers 
(6.1/7.1), such as Dolby Digital EX, DTS-ES and 
Dolby Pro Logic IIz Height are unavailable.

• When the “Powered Zone 2” setting is set to “Act” and 

the input selector of Zone 2 is selected, power 
consumption on standby mode slightly increases.

Note:
To control Zone 2, you must press the remote 
controller’s [ZONE 2] button first.

Zone 2 turns on and ZONE 2 indicator 
lights up.

To select the same source as that of the 
main room, press the [ZONE 2] button 
repeatedly until “Z2 Sel: Source” 
appears.

To select AM or FM press the 
[TUNER] input selector button 
repeatedly.

Note:
You cannot select different AM or FM 
radio stations for your main room, 
Zone 2. The same AM/FM radio station 
will be heard in each room.

Press the [ZONE 2] button, then 
point the remote controller at the 
AV receiver and press the 
[ON/STANDBY] button.
Zone 2 turns on and ZONE 2 indicator 
lights up.

To select an input source for 
Zone 2, press the [ZONE 2] 
button, followed by an INPUT 
SELECTOR button.
To select AM or FM press the 
[TUNER] INPUT SELECTOR button 
repeatedly.

Note:
You cannot select different AM or FM 
radio stations for your main room, 
Zone 2. The same AM/FM radio station 
will be heard in each room.