ONKYO SKW-750X Manual Do Utilizador

 

45

 

The right surround back speaker has been detected 
but the left surround back speaker hasn’t.

There is a problem with a speaker. The speaker may 
be broken or the subwoofer may be emitting sound 
that is too high.

The number of speakers detected on the second or 
third measurement was different to the number 
detected on the first measurement.

Make sure speakers that cannot be detected are con-
nected properly.

 

:  Return to step 2 and try again.

 

:  Cancel the automatic speaker setup.

 

❏

 

This message appears if saving fails.

Try saving again. If this message appears after 2 or 3 
attempts, the AV receiver is probably malfunctioning. 
Contact your Onkyo dealer.

 

:  Return to step 2 and try again.

 

:  Cancel the automatic speaker setup.

 

If you wish to make changes to the settings found during 
the automatic speaker setup, follow the directions on 
pages 74–78.

 

If you’re using a powered subwoofer and it outputs very 
low-frequency sound at a low volume level, it may not be 
detected by the automatic speaker setup. If the sub-
woofer (SW) appears on the “SP Detect Result” screen 
as “No”, increase the subwoofer’s volume to the half-
way point, set it to its highest crossover frequency, and 
then try running the automatic speaker setup again. Note 
that if the volume is set too high and the sound distorts, 
detection issues may occur, so use an appropriate 
volume level.

Press the [ENTER] button.
Make sure speakers that cannot be 
detected are connected properly.

HT-S6100_En.book Page 45 Tuesday, July 1, 2008 4:58 PM