ONKYO HT-R550 Manual Do Utilizador

Controlling Other Components

—Continued

Onkyo components that are connected via

are con-

trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.

If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via

, use

the following remote control codes:
• [DVD] REMOTE MODE button

0627:

Onkyo DVD player without

(default)

• [CD/MD/CDR/DOCK] REMOTE MODE button

1817:

Onkyo CD player without

(default)

0868:

Onkyo MD recorder without

1323:

Onkyo CD recorder without

2990:

Onkyo RI Dock without

Note:

If you connect an

-capable Onkyo MD recorder, CD

recorder, or RI Dock component to the TAPE IN/OUT or
CBL/SAT jacks, for remote operation to work properly,
you must set the Input Display to MD, CDR, or DOCK
(see page 41).

You can reset a REMOTE MODE button to its default
remote control code.

You can reset the remote controller to its default settings.

Remote Control Codes for Onkyo
Components Connected via

Make sure the Onkyo component is con-
nected with an

cable and an analog

audio cable (RCA).

See page 35 for details.

Enter the appropriate remote control code
for the [DVD] or [CD] REMOTE MODE but-
ton.

[DVD] REMOTE MODE button

1612:

Onkyo DVD player with

[CD/MD/CDR/DOCK] REMOTE MODE button

1327:

Onkyo CD player with

1808:

Onkyo MD recorder with

1322:

Onkyo CD recorder with

1993:

Onkyo RI Dock with

See the previous page for how to enter remote
control codes.

Press the [DVD] or [CD] REMOTE MODE
button, point the remote controller at the
AV receiver, and operate the component.

Resetting REMOTE MODE Buttons

While holding down the REMOTE
MODE button that you want to
reset, press the [L NIGHT] button
for 3 seconds.

The REMOTE MODE button lights up.

Press the REMOTE MODE button
again.

The REMOTE MODE button flashes
twice, indicating that it’s been reset.

The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers respectively. When these buttons
are reset, the preprogrammed code is
restored.

Resetting the Remote Controller

While holding down the
[RECEIVER] REMOTE MODE but-
ton, press the [L NIGHT] button
for 3 seconds.

The [RECEIVER] button lights up.

Press the [RECEIVER] REMOTE
MODE button again.

The [RECEIVER] button flashes twice,
indicating that it’s been reset.

M D/CDR

DOCK

CABLE

REMOTE MODE

SAT

VCR

T V

DVD

C D

L NIGHT