ONKYO SKC-750XC Manual Do Utilizador

 

40

 

With 

 (Remote Interactive), you can use the following special functions:

 

When you start playback on a component connected via 

, if the AV receiver is on Standby, it will automatically turn 

on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components 
connected via 

 will also go on Standby.

 

When playback is started on a component connected via 

, the AV receiver automatically selects that component as 

the input source. If your DVD player is connected to the AV receiver’s DVD IN (multichannel input), you’ll need to 
press the [MULTI CH] button repeatedly and select Multich to hear all channels (see page 50), as the Direct Change 

 

function selects the DVD IN FRONT L/R jacks.

 

You can use the AV receiver’s remote controller to control your other 

-capable Onkyo components. You must enter 

the appropriate remote control code first (see page 85). And remember to point the remote controller at the AV receiver 
and not the other component.

 

• Use only 

 cables for 

 connections. 

 cables 

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two 

 jacks. You can con-

nect either one to the AV receiver. The other jack is 
for connecting additional 

-capable components.

• Connect only Onkyo components to 

 jacks. Con-

necting other manufacturer’s components may cause 
a malfunction.

• Some components may not support all 

 functions. 

Refer to the manuals supplied with your other Onkyo 
components.

 

• Plug the end of the power cord into a suitable wall outlet.

• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment 

on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2: Make the necessary 

 connections (see illustration below).

Step 3: If you’re using an MD or CDR component, change the Input Display (see page 48).

HT-S6100_En.book Page 40 Tuesday, July 1, 2008 4:58 PM