ONKYO HT-S4100 Manual Do Utilizador

 

11

 

For detailed information, see the pages in parentheses.

 

A

 

Red:

 Subwoofer in standby mode

Blue:

 Subwoofer on

With the Auto Standby function, the SKW-460 
automatically turns on when an input signal is 
detected in Standby mode. When there’s no input 
signal for a while, the SKW-460 automatically 
enters Standby mode.

 

B

 

This control is used to adjust the volume of the sub-
woofer.

 

C

 

This RCA input should be connected to the sub-
woofer pre out on the AV receiver with supplied 
RCA cable.

 

The Auto Standby function turns the subwoofer on when 
the input signal exceeds a certain level. If the Auto 
Standby function does not work reliably, try slightly 
increasing or decreasing the subwoofer output level on 
the AV receiver (page 56).

 

If the subwoofer is placed on a hard 
floor (wood, vinyl, tile, etc.) and 
playback is very loud, the sub-
woofer's feet may damage the floor-
ing. To prevent this, place the 
supplied pads underneath the sub-
woofer's feet. The pads also provide 
a stable base for the subwoofer.

 

1

 

These keyhole slots can be used to wall-mount the 
speaker. See page 23 for mounting instructions.

 

2

 

These push terminals are for connecting the speaker 
to the TX-SR304 with the supplied speaker cables. 
The supplied speaker cables are color-coded for 
easy identification. Simply connect each cable to the 
same-colored positive speaker terminal.

 

3

 

These threaded inserts can be used to attach the 
speaker either horizontally or vertically to a speaker 
mount or bracket.

 

Use commercially available 1/4" screws to attach 
the speaker to a speaker mount or bracket.

1

2

3

■ Rear

To AC outlet

■ Front

1

2

3

■ Rear

HT-S4100_En.book Page 11 Friday, February 22, 2008 2:15 PM