ONKYO HT-S4100 Manual Do Utilizador

 

57

 

• A quicker way to adjust the speaker levels is to press 

the remote controller’s [TEST TONE] button to output 
the test tone, use the [LEVEL–] and [LEVEL+] but-
tons to adjust the levels, and use the [CH SEL] button 
to select the speakers.

• If the multichannel input is selected (page 41), in step 

2, the “3. MultiLevel” menu appears instead of the 
“3. Level Cal” menu, and you can adjust the level of 
each channel of the multichannel input regardless of 
the Speaker Configuration settings.
You can adjust the volume of each speaker from –
12 dB to +12 dB (–30 dB to +12 dB for the sub-
woofer).

The following table shows the display indicators for each 
supported digital signal format.

Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you 
can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut 

off, try setting the format to PCM.

• If noise is produced when fast forwarding or reversing 

a DTS CD, try setting the format to DTS.

 

The level can be adjusted from –12 to 
+12 dB in 1 dB steps (–15 to +12 dB 
for the subwoofer).

 

Speakers that you set to No or None in 
the Speaker Configuration (page 38) do 
not output the test tone.

 

Setup closes.
Don’t forget to turn down the volume if 
you turned it up while setting the levels.
When you want to go back up one 
menu level to “Level Cal,” press the 
[RETURN] button.

 

The DTS or PCM indicator, 

depending on which format you have set, flashes, 
and only signals in that format are output. Digital 
signals in other formats are ignored.

 

The format is detected automati-

cally. If no digital input signal is present, the cor-
responding analog input is used instead.

HT-S4100_En.book Page 57 Friday, February 22, 2008 2:15 PM