ONKYO HT-S4100 Manual Do Utilizador

 

61

 

• Make sure your iPod is actually playing.
• Make sure your iPod is inserted properly in the RI 

Dock.

• Make sure the RI Dock is connected to the correct 

input jacks on the AV receiver. Do not connect it to 
any output jacks.

• Make sure the AV receiver is turned on, the correct 

input source is selected, and the volume is turned up.

• Make sure the plugs are pushed in all the way.
• Make sure the AC adapter is connected to a suitable 

wall outlet and connected to the RI Dock.

• Try resetting your iPod.

 

• 3rd generation iPods are not supported.
• Make sure your iPod is properly inserted in the RI 

Dock. If your iPod is in a case, it may not connect 
properly to the RI Dock. Always remove your iPod 
from the case before inserting it into the RI Dock.

• The iPod cannot be operated while it’s displaying the 

Apple logo.

• Make sure you’ve selected the right remote mode.
• Check the RI Dock’s RI MODE switch setting.
• When you use the AV receiver’s remote controller, 

point it toward your AV receiver.

• The RI Dock must be connected to the AV receiver 

with both an 

 cable and an audio cable.

• If you still can’t control your iPod, start playback by 

pressing your iPod’s Play button. Remote operation 
should then be possible. 

 

• Always pause iPod playback before selecting a differ-

ent input source. If playback is not paused, the Direct 
Change function may select your iPod as the input 
source by mistake during the transition between 
tracks.

 

• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT, or 
VIDEO 1 IN to VIDEO 1 OUT).

 

• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct.

 

• Use the “Multiplex” setting on the “4. Audio Adjust” 

menu to select Main or Sub (page 52).

 

• To use 

, you must make an 

 connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 35).

 

The AV receiver contains a microcomputer for signal pro-
cessing and control functions. In very rare situations, 
severe interference, noise from an external source, or 
static electricity may cause it to lockup. In the unlikely 
event that this happens, unplug the power cord from the 
wall outlet, wait at least five seconds, and then plug it 
back in again.

Onkyo is not responsible for damages (such as CD 
rental fees) due to unsuccessful recordings caused by 
the unit’s malfunction. Before you record important 
data, make sure that the material will be recorded cor-
rectly.

Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.

HT-S4100_En.book Page 61 Friday, February 22, 2008 2:15 PM