ONKYO HTP-360 Manual Do Utilizador

 

48

 

This chapter explains how to record the selected input 
source to an AV component with recording capability, 
and how to record audio and video from two different 
sources.

You can record only to AV components that are con-
nected to the TAPE OUT or VIDEO 1 OUT jacks.
See pages 26–36 for information on connecting your AV 
components to the AV receiver. 

 

• You cannot record from AV components that are con-

nected to the digital inputs. You must use analog con-
nections.

• The surround effects produced by the surround and 

DSP listening modes cannot be recorded.

• You cannot record from an AV component that is con-

nected to the multichannel input.

• If you select another input source while recording, that 

input source will be recorded instead.

With this function, you can record audio and video from 
different sources, allowing you to overdub audio onto 
your video recordings. This function takes advantage of 
the fact that when an audio-only input source (i.e., 
TAPE, TUNER, or CD) is selected, the video input 
source remains unchanged. For example, if you first 
select the VIDEO 3 input source, followed by the CD 
input source, you can watch the video from the VIDEO 3 
input and listen to the audio from the CD input.

In the following example, audio from the CD player con-
nected to the CD IN jacks, and video from the camcorder 
connected to the VIDEO 3 IN jack are recorded by the 
VCR, which is connected to the VIDEO 1 OUT jacks.

 

This selects the CD player as the audio source, but 
leaves the camcorder as the video source.

 

The video from the camcorder and the audio from 
the CD player are recorded by the VCR.

 

Audio signals from the selected input 
source are output by the VIDEO 1 OUT 
and TAPE OUT jacks.
You can listen to the source while 
recording. The AV receiver’s VOL-
UME control has no effect on record-
ing.

HT-S3100_3105_En.book Page 48 Friday, February 1, 2008 9:14 AM