ONKYO HTP-360 Manual Do Utilizador

 

60

 

• Make sure that the batteries are installed with the cor-

• Make sure that the remote controller is not too far 

away from the AV receiver, and that there’s no 
obstruction between the remote controller and the AV 
receiver’s remote control sensor (page 19).

• Make sure you’ve selected the correct remote control-

• Make sure you’ve entered the correct remote control 

code.

 

• Make sure you’ve selected the correct remote control-

• If you’ve connected an 

-capable Onkyo MD 

recorder, CD recorder, or next generation HDD-com-
patible component to the TAPE IN/OUT jacks, or a 
DS-A1 Remote Interactive Dock to the VIDEO 3 IN 
jacks, for the remote controller to work properly, you 
must set the Input Display to MD, CDR, or HDD (see 
page 38).

• To control an Onkyo component that’s connected via 

, point the remote controller at the AV receiver. 

 

• Make sure your iPod is actually playing.
• Make sure your iPod is inserted properly in the RI 

Dock.

• Make sure the RI Dock is connected to the correct 

input jacks on the AV receiver. Do not connect it to 
any output jacks.

• Make sure the AV receiver is turned on, the correct 

input source is selected, and the volume is turned up.

• Make sure the plugs are pushed in all the way.
• Make sure the AC adapter is connected to a suitable 

wall outlet and connected to the RI Dock.

• Try resetting your iPod.

 

• Make sure that your iPod’s TV OUT setting is set to 

On.

• Make sure the correct input is selected on your TV or 

the AV receiver.

• Some versions of the iPod do not output video.

 

• 3rd generation iPods are not supported.
• Make sure your iPod is properly inserted in the RI 

Dock. If your iPod is in a case, it may not connect 

properly to the RI Dock. Always remove your iPod 
from the case before inserting it into the RI Dock.

• The iPod cannot be operated while it’s displaying the 

Apple logo.

• Make sure you’ve selected the right remote mode.
• Check the RI Dock’s RI MODE switch setting.
• When you use the AV receiver’s remote controller, 

point it toward your amp.

• The RI Dock must be connected to the AV receiver 

with both an 

 cable and an audio cable.

• If you still can’t control your iPod, start playback by 

pressing your iPod’s Play button. Remote operation 
should then be possible. 

 

• Always pause iPod playback before selecting a differ-

ent input source. If playback is not paused, the Direct 
Change function may select your iPod as the input 
source by mistake during the transition between 
tracks.

 

• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT, or 
VIDEO 1 IN to VIDEO 1 OUT).

 

• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct.

 

• Use the “Multiplex” setting on the “4. Audio Adjust” 

menu to select Main or Sub (page 51).

 

• To use 

, you must make an 

 connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 36).

HT-S3100_3105_En.book Page 60 Friday, February 1, 2008 9:14 AM