ONKYO SKM-540S Manual Do Utilizador

 

63

 

• Relocate your antenna.
• Move the AV receiver away from your TV or com-

puter.

• Listen to the station in mono (page 38).
• When listening to an AM station, operating the remote 

controller may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

antenna.

 

• Make sure that the batteries are installed with the cor-

• Make sure that the remote controller is not too far 

away from the AV receiver, and that there’s no 
obstruction between the remote controller and the AV 
receiver’s remote control sensor (page 13).

• Make sure you’ve selected the correct remote control-

• Make sure you’ve entered the correct remote control 

 

• Make sure you’ve selected the correct remote control-

• If you’ve connected an 

-capable Onkyo MD 

recorder, CD recorder, or next generation HDD-com-
patible component to the TAPE IN/OUT jacks, or a 
DS-A1 Remote Interactive Dock to the VIDEO 2 IN 
jacks, for the remote controller to work properly, you 
must set the Input Display to MD, CDR, or HDD (see 
page 35).

• The entered remote control code may not be correct. If 

more than one code is listed, try each one.

• With some AV components, certain buttons may not 

work as expected, and some may not work at all.

• To control an Onkyo component that’s connected via 

, point the remote controller at the AV receiver. Be 

sure to enter the appropriate remote control code first 
(see page 59).

• To control an Onkyo component that’s not connected 

via 

, or another manufacturer’s component, point 

the remote controller at the component. Be sure to 
enter the appropriate remote control code first (see 
page 58).

 

• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT, or 
VIDEO 1 IN to VIDEO 1 OUT).

• When the Pure Audio listening mode is selected, 

recording is not possible because no video signals are 
output. Select another listening mode.

 

• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, or Pure Audio (not North American 
model).

 

• The display is turned off when the Pure Audio (not 

North American model) listening mode is selected.

 

• Use the “Multiplex” setting on the “4. Audio Adjust” 

 

• To use 

, you must make an 

 connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 33).

HT-S790_En.book Page 63 Friday, February 17, 2006 3:28 PM