Yamaha DVX-700 Manual Do Utilizador

■ Using a USB device

You can play back audio files, and picture files saved on 
your USB devices.

The DVD controller supports USB mass storage class 
devices (e.g., flash memories, card readers, portable audio 
players) using FAT16 or FAT32 format.

– Some devices may not work properly even if they 

meet the requirements.

– If “USB ERROR” or “NO USB” appears in the 

front panel display, see the following methods.
– Set the system to the standby mode, and then 

turn it on again.

– Disconnect the device when the DVD controller 

is in the standby mode, then connect it again and 
turn on the DVD controller.

– Set the input source to USB, then remove and 

insert the USB device.

– Select the input source other than USB, then Set 

it back to USB again.

– Connect the AC adapter if the adapter is supplied 

with the device. 

– If the electrical power consumption of the USB 

device is high, the USB device may not be used 
correctly.

– Do not connect devices other than USB mass 

storage class devices: USB chargers, USB hubs, 
PCs, etc.

Yamaha and suppliers accepts no liability for the loss of 
data saved on the USB devices connected to the DVD 
controller. As a precaution, it is recommended that the 
files are tested after they have been saved on.

1 Press DVD/USB repeatedly until “USB” appears in 

the front panel display.

2 Connect your USB device to the USB terminal of the 

DVD controller.

3 Start playback in either of the following ways.

Press h to start playback.

Press MENU to open Disc Navigator. 
Press 

 / 

 / 

 / 

 to select files, then press h.

Refer to page 34 for how to select files. 

4 Press s to stop playback. Before you remove the 

USB device, select an input source other than USB.

When the input source is USB, you cannot open the 
DVD setup menu.