Yamaha DVX-700 Manual Do Utilizador

– The next time you turn on the system after 

selecting an item between 1 and 4 in the system 
menu, the system starts with DVD as an input 
source.

■ Setting the preset code

You can use the remote control to control the power, TV 
input, channel, and volume for up to two components, 
such as TV or Set top box (STB). Set the preset codes 
depending on the components.

The preset cords are set to “298” (TV) and “748” 
(STB) as the default settings.

1 Switch TV/STB to the side you want to set.

2 Press and hold CODE SET, then press POWER.

3 Point the remote control toward the remote control 

sensor on the DVD controller and enter a 3-digit code 
while holding CODE SET.
Refer to “LIST OF PRESET CODES” on the 
appendix for the corresponding codes.

4 Release CODE SET.

If the preset cord is set correctly, “PRESET OK!” 
appears in the front panel display.

If you have failed to set the preset code, “PRESET 
NG!” appears in the front panel display. Try to set it 
again.

– When you select the preset cord for “cable” or 

“DBS”, you can use only POWER and CH +/–. If 
a preset cord for “TV” is set on the other side, you 
can use TV VOL +/– or TV INPUT to control TV.

– To set another preset code, switch TV/STB to the 

other side and repeat the step 2 to step 4.

Once you set the preset code, you can operate your TV/
STB.

1 Switch TV/STB to the side, which the preset code is 

set.

2 Press the button you want to operate.

TV/ STB

Switches TV or STB.