Viper FANG 20T-EU Manual Do Utilizador
USER MANUAL
ENGLISH
BATTERY CHARGING
NOTE
For the best machine performance, keep batteries charged at all times. Do not let them sit in a discharged condition.
CAUTION!
Use only approved chargers with the following specifications:
z
Automatic shut off circuit
z
Deep cycle charging
z
Output current of 10-20 Amps
z
Output voltage of 24 Volts
CAUTION!
Batteries are dangerous! Batteries emit hydrogen gas and an explosion or fire can result. Keep sparks and fire
away from batteries at all times. When charging the machine, make sure the battery compartment is left open.
away from batteries at all times. When charging the machine, make sure the battery compartment is left open.
1.
Place charge and machine in a well ventilated area.
2.
Turn machine off.
3.
Open recovery tank up, exposing battery compartment .
4.
Check fluid level in each battery cell. Do not charge batteries unless fluid is slightly covering the battery plates. Do not overfill the
batters. Overfilling may cause the batteries to overflow during charging due to expansion. Replace the caps prior to charging.
batters. Overfilling may cause the batteries to overflow during charging due to expansion. Replace the caps prior to charging.
5.
Plug approved charger into grounded wall out let before plugging the charger into the machine.
6.
Plug charger into red charger receptacle located in the front left of the battery compartment.
7.
Flip up the recovery tank “Kick stand” and gently lay the recovery tank down until it rests on the stand.
8.
The charter will automatically begin to charger the batteries, and it will automatically shut down once the batteries are fully
charged.
charged.
9.
Upon completion of charging, first unplug the charger from the wall outlet, and then disconnect the charger from the machine.
10. Check the battery level after charging is complete. If fluid level is low, add distilled water to bring the fluid level up to the bottom of
the sight tubes. Replace the caps and wipe the batteries down with a towel.
82089E(1)2009-04A SCRUBBERS FANG20-EU / FANG20T-EU 17