Melissa 640-132 Manual Do Utilizador
24
25
24
25
Using the vacuum cleaner
. Make sure the hand-held vacuum cleaner
. Make sure the hand-held vacuum cleaner
has been correctly fitted to the appliance.
2. Attach the floor nozzle (21) by inserting
the connector (9) into the terminal at the
point of the appliance and screwing the
mounting screw (20) into the connector on
the floor nozzle.
point of the appliance and screwing the
mounting screw (20) into the connector on
the floor nozzle.
3. Turn on the appliance by pushing the
on/off button (2) on the foldable handle ()
forward. The appliance has two setting:
forward. The appliance has two setting:
o “FLOOR” is for cleaning hard surfaces
(stone floors, wooden floors etc.).
o “CARPET” is for cleaning carpets and
rugs (the brush (22) inside the floor
nozzle rotates).
4. Push the on/off button backward to the
(stone floors, wooden floors etc.).
o “CARPET” is for cleaning carpets and
rugs (the brush (22) inside the floor
nozzle rotates).
4. Push the on/off button backward to the
“OFF” position to swith off the appliance.
Using the hand-held vacuum cleaner
. Detach the hand-held vacuum cleaner
. Detach the hand-held vacuum cleaner
from the appliance by pressing the release
button (4) whilst simultaneously pulling the
hand-held vacuum cleaner upwards.
button (4) whilst simultaneously pulling the
hand-held vacuum cleaner upwards.
2. Push the on/off button (6) forward to switch
on the appliance and backward to switch it
off.
off.
3. The crevice nozzle
(13) is fitted to the
hand-held vacuum
cleaner and can
be extended from
the nozzle tip (2)
when cleaning
difficult to reach
spots (see illustration).
hand-held vacuum
cleaner and can
be extended from
the nozzle tip (2)
when cleaning
difficult to reach
spots (see illustration).
4. Attach the hand-held vacuum into the
hollow on the appliance until you hear a
click, once you have finished using it.
click, once you have finished using it.
NOTE:
• If the appliance loses suction power during
• If the appliance loses suction power during
use, the battery may need to be recharged.
• Lack of suction power may also be caused
by the filter being blocked and needing
cleaning (see “Cleaning of dust container
and emptying of filter”).
cleaning (see “Cleaning of dust container
and emptying of filter”).
• If the appliance still does not have full
suction power after cleaning or replacing
the filter, the nozzle tip or the nozzle may
be blocked.
the filter, the nozzle tip or the nozzle may
be blocked.
• NOTE: Check cause of fault and correct.
Do not use the appliance if any air holes
are blocked. Permanent motor damage
can result.
are blocked. Permanent motor damage
can result.
• We recommend that you empty the dust
container after each vacuuming (see
“Emptying of dust container and cleaning
of filter” below).
“Emptying of dust container and cleaning
of filter” below).
Tips!
To save room
during storage,
the handle of the
appliance may
be folded. Press
down the release
button for the foldable handle (3) and tilt the
handle toward the appliance (see illustration).
To save room
during storage,
the handle of the
appliance may
be folded. Press
down the release
button for the foldable handle (3) and tilt the
handle toward the appliance (see illustration).
DUST CONTAINER AND FILTER
This appliance is not equipped with a dust
bag. The dust/dirt is sucked up into the
transparent dust holder instead. Once the
dust is in this container, it whirls around so
that it does not block suction. The air sucked
in is cleaned by means of a two-component
washable permanent filter in the dust
container.
This appliance is not equipped with a dust
bag. The dust/dirt is sucked up into the
transparent dust holder instead. Once the
dust is in this container, it whirls around so
that it does not block suction. The air sucked
in is cleaned by means of a two-component
washable permanent filter in the dust
container.
Emptying of dust container and cleaning of
filter
IMPORTANT! If the appliance loses suction
power during use, the filter pad may be dirty,
and needs cleaning or replacing. Never use the
appliance, when the filter is dirty or when it has
not been fitted.
. Detach the hand-held vacuum cleaner
filter
IMPORTANT! If the appliance loses suction
power during use, the filter pad may be dirty,
and needs cleaning or replacing. Never use the
appliance, when the filter is dirty or when it has
not been fitted.
. Detach the hand-held vacuum cleaner
from the appliance by pressing the release
button whilst simultaneously pulling the
hand-held vacuum cleaner upwards.
button whilst simultaneously pulling the
hand-held vacuum cleaner upwards.
2. Grab the dust container with one hand and
press the opening button (7) to release the
dust container from the motor section (4)
(see illustration).
dust container from the motor section (4)
(see illustration).
3. Pull the two parts of the filter out of the
dust container and empty the container.
If necessary,
rinse the dust
container with
clean water
and wipe the
container with a
dry cloth.
If necessary,
rinse the dust
container with
clean water
and wipe the
container with a
dry cloth.