Ridgid WD14500 Manual Do Utilizador

Página de 54
6
Filter Removal and Installation
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
!
Removal and Installation
of the Qwik Lock™ Filter
Filter Removal:
1. Hold the filter tabs of the Qwik Lock™
filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated filter plate, lift up on the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.
Filter Installation:
1. Carefully slide the Qwik Lock™ filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the filter
seats securely around the base of the
filter cage and against the lid.
2. Align the small center hole in the top of
the filter over the Qwik Lock™ stud on
the filter cage. Press firmly on top of
the filter near the stud to allow the filter
to snap over the ball on the end of the
stud. The filter is now attached.
Filter 
Cage
Qwik 
Lock™
Stud
Filter 
Tabs (2)
Integrated Filter 
Plate with Center 
Hole
PUSH 
DOWN
PULL 
UP
Rubber 
Gasket at 
Bottom of 
Filter
 
(cutaway 
view)
Lid
NOTE: Failure to properly seat the
bottom gasket could result in debris
bypassing the filter.
SP6735-3 RIDGID ES  6/13/12  2:35 PM  Page 6