Kenwood 144 Manual Do Utilizador
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
34
1 Press [MENU] to enter Menu mode.
2 Press [1], [5], [2] to select “1–5–2 (SCAN
RESUME)”.
3 Press [UP]/ [DWN] to select Time-Operated (default),
Carrier-Operated, or Seek.
4 Press [OK] to complete the setting.
5 Press [MENU] to exit Menu mode.
SELECTING SCAN RESUME METHOD
The transceiver stops scanning at a frequency (or
memory channel) on which a signal is detected. It then
continues scanning according to which resume mode
you select. You can choose one of the following modes.
The default is Time-operated mode.
memory channel) on which a signal is detected. It then
continues scanning according to which resume mode
you select. You can choose one of the following modes.
The default is Time-operated mode.
•
Time-Operated mode
The transceiver remains on a busy frequency (or
memory channel) for approximately 5 seconds, and
then continues to scan even if the signal is still
present.
memory channel) for approximately 5 seconds, and
then continues to scan even if the signal is still
present.
•
Carrier-Operated mode
The transceiver remains on a busy frequency (or
memory channel) until the signal drops out. There is
a 2 second delay between signal drop-out and scan
resumption.
memory channel) until the signal drops out. There is
a 2 second delay between signal drop-out and scan
resumption.
•
Seek mode
The transceiver remains on a busy frequency (or
memory channel) even after the signal drops out and
does not automatically resume scanning.
memory channel) even after the signal drops out and
does not automatically resume scanning.
Note: To temporarily stop scanning and monitor weak signals, press and
hold [MONI]. Release the key to resume scanning.
hold [MONI]. Release the key to resume scanning.
TH-D7 E 33 Scan
98.12.4, 0:11 PM
34