Sears 153.321342 Manual Do Utilizador

8. Clean the area around the element opening. Remove

any sediment from or around the element opening, inside

the tank.

9. If you are cleaning the element you have removed, do so by

scraping or soaking in vinegar or a de-liming solution.

Replacement elements must (1) be the same voltage and (2)

no greater wattage than listed on the model rating plate affixed

to the water heater.

10. A new gasket should be used in all cases to prevent a

possible water leak. (See Element Gasket in the “Repair Parts

List ” Chart). Place the new element gasket on the thread side

of the cleaned or new element and screw into tank, securing

tightly using an element wrench.

FIGURE 37.

11. Close the water heater drain valve by turning the handle to

the right (clockwise). The drain valve is on the lower front of

the water heater.

12. Open the cold water supply valve to the water heater.

NOTE: The cold water supply valve must be left open when the

water heater is in use.

13. To insure complete filling of the tank, allow air to exit by

opening the nearest hot water faucet. Allow water to run until

a constant flow is obtained. This will let air out of the water

heater and the piping.

Never use this water heater unless it is completely full of water.

To prevent damage to the tank and heating element, the tank

must be filled with water. Water must flow from the hot water

faucet before turning “ON” power.

14. Check element for water leaks. If leakage occurs, tighten

element or repeat steps 2 and 3, remove element and

reposition gasket. Then repeat steps 10 through 14.

15. Reconnect the two wires to the element and then check to

make sure the thermostat remains firmly against the surface

of the tank.

FIGURE 38.

16. Replace terminal cover on thermostat making sure that the

locking tabs on the terminal cover are in place.

FIGURE 39.

17. Place the insulation cap with handle so that it completely

covers the thermostat and element.

FIGURE 40.