Honeywell TH1210DN Manual Do Utilizador

ENGLISH

M32805

Remove the wallplate from the thermostat
as shown at left, then follow directions
below for mounting.

1.  Pull wires through wire hole.

2.  Position wallplate on wall, level and mark hole

positions with pencil.

3.  Drill holes at marked positions as shown below,

then tap in supplied wall anchors.

4.  Place wallplate over anchors, insert and tighten

mounting screws.

Pull at bottom to remove thermostat

from wallplate.

CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before beginning

installation.

Drill 3/16" holes for drywall. Drill 7/32" holes for plaster.

MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not

place the old control in the trash. Contact the Thermostat Recycling Corporation at 

www.thermostat-recycle.org or 800-238-8192 for information on how and where to

properly and safely dispose of your old thermostat.

M32731

TO REMOVE WALLPLATE

PULL HERE

Wall anchors

Mounting screws

Wire hole